|
Post by djm16 on Sept 29, 2018 5:16:43 GMT
Has anyone used one of these before? Is it suitable for use on 1mm pressed steel? I am thinking of getting one to clean up the inner wing / A-post area while I have a front wing off for repair.
|
|
|
Post by Phil Nottingham on Sept 29, 2018 7:05:26 GMT
They are useful for scaling of tough spots of rust but 1mm gauge is really too thin so I would use it only on the really patchy spots and it could well perforate it in parts if heavy handed
I did use it on the rear inner wings "chassis" legs area as there are several layers of sheet steel
|
|