|
Post by eisdielenbiker on Sept 27, 2008 19:04:19 GMT
Hello, i am going to have my Rovers drivers side D-Post welded next week. Any hints are welcome. The D-Post trim is held by 2 clips and 2 screws. I removed the screws first and then i undid the clips taking care of not pulling on the cardboard but on the metal clip retainer attached to that. Hope you can make use of this. I always enjoy photograps published here on procedures and internals you cannot read in the books. Mark
|
|
|
Post by Warwick on Sept 29, 2008 0:16:07 GMT
Yes, very helpful. Thanks Mark.
|
|
|
Post by Phil Nottingham on Oct 9, 2008 16:26:13 GMT
Ensure that the special black fibre "tacking" strip is removed in one pieced if possible as this is NLA last time I tried. If not it will be difficult to stapel/tack the new Furflex back on
|
|